(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for Power Seat
for Manual Seat
NG -- REPLACE FLOOR WIRE
OK -- Continue to next step.
6. CHECK FRONT SEAT INNER BELT ASSEMBLY LH
(a) Connect the connectors to the center airbag sensor assembly and the front seat inner belt assembly LH.
(b) Connect the cable to the negative (-) battery terminal.
(c) Turn the ignition switch to ON, and wait for at least 60 seconds.
(d) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
No comments:
Post a Comment