2010 Toyota Corolla L4-1.8L (2ZR-FE) B Code Charts Page 341

Trouble Codes/DTC Check / Clear.

OK:

DTC B1825, B1826, B1827, B1828, or 56 is not output.

Result

Result

HINT

Codes other than DTC B1825, B1826, B1827, B1828, and 56 may be output at this time, but they are not related to this check.

C -- REPLACE FRONT SEAT ASSEMBLY LH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front

Seat Assembly (for Manual Seat)/Removal

B -- REPLACE FRONT SEAT ASSEMBLY LH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front

Seat Assembly (for Power Seat)/Removal

A -- Continue to next step.

3. CHECK FLOOR WIRE (SIDE SQUIB LH CIRCUIT)

(a) Turn the ignition switch off.

(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

(c) Disconnect SST from connector C.

(d) Disconnect the floor wire from the center airbag sensor assembly.

(e) Check for a short to B+ in the circuit.

(1) Connect the cable to the negative (-) battery terminal.

(2) Turn the ignition switch to ON.

(3) Measure the voltage according to the value(s) in the table below.