(e) Reconnect the ignition coil assembly connectors.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (IGNITION COIL ASSEMBLY - ECM)
OK -- Continue to next step.
4. CHECK WHETHER DTC OUTPUT RECURS (DTC P0351, P0352, P0353 OR P0354)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Clear DTCs See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
(e) Shuffle arrangement of the ignition coils with igniters (among No. 1 to No. 4 cylinders).
NOTICE:
Do not shuffle the connectors.
(f) Perform a simulation test.
(g) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(h) Read the DTCs.
Result:
B -- REPLACE IGNITION COIL ASSEMBLY
A -- REPLACE ECM See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Removal
5. CHECK HARNESS AND CONNECTOR (IGNITION COIL ASSEMBLY - INTEGRATION RELAY)
(a) Disconnect the ignition coil assembly connectors.
No comments:
Post a Comment