(b) Connect SST (resistance 2.1 Ohms) to connector E (orange connector).
CAUTION:
Never connect the tester to the front passenger airbag assembly (front passenger side squib) for measurement, as this may lead to
a serious injury due to airbag deployment.
NOTICE:
- Do not forcibly insert SST into the terminals of the connector when connecting.
- Insert SST straight into the terminals of the connector.
SST : 09843-18061
(c) Connect the cable to the negative (-) battery terminal.
(d) Turn the ignition switch to ON, and wait for at least 60 seconds.
(e) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(f) Turn the ignition switch off.
(g) Turn the ignition switch to ON, and wait for at least 60 seconds.
(h) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
OK:
DTC B1805, B1806, B1807, B1808, or 52 is not output.
HINT
Codes other than DTC B1805, B1806, B1807, B1808, and 52 may be output at this time, but they are not related to this check.
NG -- CHECK FRONT PASSENGER SIDE SQUIB CIRCUIT
OK -- REPLACE FRONT PASSENGER AIRBAG ASSEMBLY See: Restraints and Safety Systems/Air Bag Systems/Air
Bag/Service and Repair/Front Passenger Airbag Assembly/Removal
3. CHECK FRONT PASSENGER SIDE SQUIB CIRCUIT
(a) Turn the ignition switch off.
No comments:
Post a Comment