(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Disconnect the floor wire from the front seat inner belt assembly LH.
(d) Connect the cable to the negative (-) battery terminal.
(e) Turn the ignition switch to ON.
(f) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
for Power Seat
for Manual Seat
NG -- REPLACE FLOOR WIRE
OK -- REPLACE FRONT SEAT INNER BELT ASSEMBLY LH See: Restraints and Safety Systems/Seat Belt Systems/Seat
Belt/Service and Repair/Front Seat Inner Belt Assembly/Removal
12. CHECK FLOOR WIRE (SHORT TO GROUND)
(a) Disconnect the floor wire from the front seat inner belt assembly LH.
No comments:
Post a Comment