NG -- REPLACE FLOOR WIRE
OK -- Continue to next step.
6. CHECK FRONT SEAT INNER BELT ASSEMBLY LH
(a) Connect the connectors to the center airbag sensor assembly and the front seat inner belt assembly LH.
(b) Connect the cable to the negative (-) battery terminal.
(c) Turn the ignition switch to ON, and wait for at least 60 seconds.
(d) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(e) Turn the ignition switch off.
(f) Turn the ignition switch to ON, and wait for at least 60 seconds.
(g) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
OK:
DTC B1655/37 is not output.
HINT
Codes other than DTC B1655/37 may be output at this time, but they are not related to this check.
NG -- REPLACE FRONT SEAT INNER BELT ASSEMBLY LH
OK -- USE SIMULATION METHOD TO CHECK See: Restraints and Safety Systems/Air Bag Systems/Testing and
Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System
7. REPLACE FRONT SEAT INNER BELT ASSEMBLY LH
(a) Turn the ignition switch off.
(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Replace the front seat inner belt assembly LH with a known good part See: Restraints and Safety Systems/Seat Belt Systems/Seat
Belt/Service and Repair/Front Seat Inner Belt Assembly/Removal.
HINT
Perform the following inspection using known good parts from another vehicle if possible.
NEXT -- Continue to next step.
8. CHECK CENTER AIRBAG SENSOR ASSEMBLY
(a) Connect the cable to the negative (-) battery terminal.
No comments:
Post a Comment