Standard Resistance (Check for Short):
(d) Reconnect the accelerator pedal position sensor connector.
(e) Reconnect the ECM connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (ACCELERATOR PEDAL POSITION SENSOR - ECM)
OK -- Continue to next step.
3. INSPECT ECM (VCPA AND VCP2 VOLTAGE)
(a) Disconnect the accelerator pedal position sensor connector.
(b) Turn the ignition switch to ON.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(d) Reconnect the accelerator pedal position sensor connector.
NG -- REPLACE ECM See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Removal
OK -- Continue to next step.
4. REPLACE ACCELERATOR PEDAL ROD ASSEMBLY
(a) Replace the accelerator pedal rod assembly See: Powertrain Management/Fuel Delivery and Air Induction/Accelerator Pedal/Service
and Repair/Removal.
NEXT -- Continue to next step.
No comments:
Post a Comment