(a) Turn the ignition switch off.
(b) Replace the rear speed sensor See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed
Sensor/Service and Repair/Rear Speed Sensor/Removal.
(c) Replace the rear axle hub and bearing assembly (rear speed sensor rotor) See: Maintenance/Wheels and Tires/Wheel Hub/Service
and Repair/Rear Axle Hub/Removal.
HINT
The rear speed sensor rotor is incorporated into the rear axle hub and bearing assembly.
If the rear speed sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly with rear
speed sensor.
NOTICE:
Check the speed sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/ABS (Antilock Brake System)/Test Mode Procedure.
NEXT -- Continue to next step.
14. RECONFIRM DTC
(a) Clear the DTCs See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/ABS (Antilock Brake System).
(b) Start the engine.
(c) Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.
(d) Check if the same DTC is recorded See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/ABS (Antilock Brake System).
Result:
HINT
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next
step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related
Diagnostic Procedures/ABS (Antilock Brake System).
B -- REPLACE BRAKE ACTUATOR ASSEMBLY See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Brake Actuator (w/o VSC)/Removal
A -- END
DTC 34-10
NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: 34-10-34-12: Error in Picture Circuit
34-12 - Excess Current in Back-light
DESCRIPTION
INSPECTION PROCEDURE
HINT
After the inspection is completed, clear the DTCs.
No comments:
Post a Comment