(a) Warm up the engine.
(b) Turn the ignition switch off.
(c) Connect Techstream to the DLC3.
(d) Turn the ignition switch to the on position.
(e) Turn on the tester.
(f) Select the item "Powertrain / Engine and ECT / Data List".
(g) According to the display on the tester, read the "Data List".
HINT
When DTC P0712 is output and Techstream output is 150锟斤拷C (302锟斤拷F), there is a short circuit.
When DTC P0713 is output and Techstream output is -40锟斤拷C (-40锟斤拷F), there is an open circuit.
Measure the resistance between terminal THO1 (THO) and body ground.
HINT
If a circuit related to the ATF temperature sensor become open, P0713 is immediately set (in 0.5 second).
When P0713 is set, P0711 cannot be detected.
It is not necessary to inspect the circuit when P0711 is set.
PROCEDURE
1. INSPECT TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)
(a) Disconnect the transmission wire connector from the transaxle.
(b) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment