* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B1925 02
- Left Seat Cushion Heater Sensor Circuit Shorted to Ground
DTC B1925 05
- Left Seat Cushion Heater Sensor Circuit Shorted to Battery or Open
DTC B2170 02
- Right Seat Heater Cushion Sensor Circuit Shorted to Ground
DTC B2170 05
- Right Seat Heater Cushion Sensor Circuit Shorted to Battery or Open
Diagnostic Fault Information
Circuit/System Description
The heated seat temperature sensor that set this diagnostic trouble code (DTC) is located in the seat cushion just under the seat cover with the seat
heating element. The rear heated seat module (RHSM) supplies a 5 V reference voltage through the temperature sensor signal circuit and a ground
through the low reference circuit to the sensor. The RHSM monitors the voltage of the sensor signal circuit to determine the temperature of the seat.
The temperature sensor varies in resistance based on the temperature of the heating element causing the signal voltage to change. Once the seat
reaches the set temperature, the RHSM will then cycle the control circuit of the heating elements ON and OFF in order to maintain the desired seat
temperature based on the feedback voltage from the sensor.
Conditions for Running the DTC
The RHSM must be powered.
Conditions for Setting the DTC
B1925 02 or B2170 02
The temperature sensor voltage drops below 0.80 V for more than 1 second.
B1925 05 or B2170 05
The temperature sensor voltage is greater than 5 V for more than 1 second.
Action Taken When the DTC Sets
The heated seat function for the affected seat will be disabled.
Conditions for Clearing the DTC
* The current DTC will clear 3 seconds after the reference voltage returns to normal operating range, and the ignition is cycled OFF then back to
No comments:
Post a Comment