锟斤拷 If greater than the specified range, test the ground circuit for an open/high resistance.
4. Verify that a test lamp illuminates between the appropriate B+ circuit terminals listed below and ground.
* Terminal 1 (IPC, PPS)
* Terminal 1 X1 (radio)
* Terminal 4 X1 (amplifier)
* Terminal 1 X2 (rear object)
锟斤拷 If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
5. If all circuits test normal, replace the appropriate module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for the appropriate module replacement, setup, and
programming.
B1335
DTC B1335
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B1335 00
- Device Power 3 Circuit
DTC B1335 0B
- Device Power 3 Circuit Current Above Threshold
DTC B1335 42
- Device Power 3 Circuit Calibration Data Set Not Programed
DTC B1335 4B
- Device Power 3 Circuit Calibration Not Learned
Diagnostic Fault Information
No comments:
Post a Comment