Conditions for Running the DTC
Ignition is in the Accessory or Run position.
Conditions for Setting the DTC
The TDM is unable to measure the ignition key transponder value.
Action Taken When the DTC Sets
* Vehicle starting will be disabled.
* The security indicator will be illuminated.
Conditions for Clearing the DTC
* A current DTC will be cleared when the TDM detects a valid transponder value from the ignition key.
* A history DTC will be cleared after 100 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.
Reference Information
Schematic Reference
Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Immobilizer
Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Immobilizer Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description and
Operation/Immobilizer Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Important: When using this diagnostic, more than one vehicle key is required to ensure proper diagnosis. If more than one key is not
available at the time of service, contact the customer and ask if any other keys can be provided for service. If unavailable, a new second key
can be created.
1. Inspect all available vehicle keys that they are correct vehicle keys.
锟斤拷 If not a correct vehicle key, replace the key.
2. While viewing the scan tool TDM Transponder Key parameter, turn ON the ignition with each of the available vehicle keys. The parameter
should read Present with all available keys.
锟斤拷 If only one key results in the parameter reading Not Present, replace the appropriate key.
锟斤拷 If all available keys result in the parameter reading Not Present, replace the TDM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Replacing Keys (North America except Canada) (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Service and
Repair/Replacing Keys (North America Except Canada))
* Control Module References (See: Testing and Inspection/Programming and Relearning) for TDM replacement, setup, and programming
No comments:
Post a Comment