Wednesday, May 13, 2020

Toyota Avalon V6-3.5L (2GR-FE) P Code Page 2096

Toyota Avalon V6-3.5L (2GR-FE) P Code Page 2096

(b) Disconnect the speed sensor connector from the transmission wire.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

NG -- REPLACE TRANSMISSION WIRE See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Wiring

Harness/Service and Repair/Removal (from 12/2010)

OK -- Continue to next step.

3. REPLACE SPEED SENSOR

NEXT -- Continue to next step.

4. CHECK IF DTC OUTPUT RECURS (SEE IF DTC P0791 AND/OR P0793 IS OUTPUT AGAIN)

(a) Connect Techstream to the DLC3.

(b) Start the engine and turn the Techstream main switch ON.

(c) Perform the monitor drive pattern See: Powertrain Management/Transmission Control Systems/Testing and Inspection/Monitors,

Trips, Drive Cycles and Readiness Codes.

(d) When you use Techstream:

Select the item "Powertrain / ECT / Trouble Codes".

(e) Read the DTCs using Techstream.

Result:

B -- END

A -- REPLACE TCM See: Powertrain Management/Transmission Control Systems/Relays and Modules - Transmission and

Drivetrain/Relays and Modules - A/T/Control Module/Service and Repair/Removal (from 12/2010)

U660E Automatic Transaxle (to 12/2010)

U660E AUTOMATIC TRANSAXLE: AUTOMATIC TRANSAXLE SYSTEM: P0796: Pressure Control Solenoid "C" Performance (Shift

Solenoid Valve SL3)

P0796 - Pressure Control Solenoid "C" Performance (Shift Solenoid Valve SL3)

SYSTEM DESCRIPTION

The TCM uses the vehicle speed signal to determine the actual gear position (1st, 2nd, 3rd, 4th, 5th or 6th gear).

No comments:

Post a Comment