Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 1018

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 1018

INSPECTION PROCEDURE

NOTICE:

* When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and note

them down before removal.

* It is necessary to perform the initialization See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring

System/Testing and Inspection/Programming and Relearning/Initialization (to 12/2010) after the registration See:

Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Testing and Inspection/Programming and

Relearning/Registration (to 12/2010) of the transmitter IDs into the tire pressure warning ECU if the ECU and/or one of the

valve and transmitters have been replaced.

PROCEDURE

1. CHECK DTC (C2173/73)

(a) Make sure that the ignition switch is off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch on (IG).

(d) Turn the Techstream on.

(e) Read the DTCs. Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.

OK:

DTC C2173/73 is not output.

NOTICE:

When DTC C2173/73 is output, troubleshoot that DTC first. Then troubleshoot DTCs C2121/21 to C2125/25.

NG -- GO TO DTC C2173/73 See: C Code Charts/C2173/Tire Pressure Monitoring (to 12/2010)

OK -- Continue to next step.

2. CHECK FREQUENCY RECEIVING CONDITION