Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 974
OK:
The speed value output from the speed sensor displayed on the Techstream is the same as the actual vehicle speed.
NG -- REPLACE ABS & TRACTION ACTUATOR ASSEMBLY
OK -- Continue to next step.
11. RECONFIRM DTC
(a) Clear the DTC See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear (from 12/2010).
(b) Start the engine.
(c) Drive the vehicle at the speed of 32 km/h (20 mph) or more for 60 seconds or more.
(d) Check that the same DTC is recorded See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear (from 12/2010).
Result:
HINT
These DTCs may be stored due to a malfunction in the connector terminal connection, etc.
B -- INSPECT SPEED SENSOR TIP
A -- END
12. INSPECT SPEED SENSOR TIP
(a) Remove the front speed sensor See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed
Sensor/Service and Repair/Front Speed Sensor/Removal.
(b) Check the sensor tip.
OK:
No scratches or foreign matter on the sensor tip.
NOTICE:
Check the speed sensor signal after cleaning or replacement See: Brakes and Traction Control/Antilock Brakes / Traction
Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure (from 12/2010).
NG -- CLEAN OR REPLACE SPEED SENSOR
OK -- CLEAN OR REPLACE SPEED SENSOR ROTOR
Initialization not Completed - Tire Pressure Monitoring (to 12/2010)
TIRE AND WHEEL: TIRE PRESSURE WARNING SYSTEM: C2177/77: Initialization not Completed
C2177/77 - Initialization not Completed
DESCRIPTION
Initialization is necessary if one of the following occurs:
* The tire pressure warning ECU is replaced.
* Any tire pressure warning valve and transmitter is replaced.
* Tires with a different tire standard pressure are installed.
* The tires are rotated.
No comments:
Post a Comment