Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 942

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 942

Standard resistance:

(e) Check for a short in the circuit.

(1) Release the activation prevention mechanism built into connector "B" See: Restraints and Safety Systems/Air Bag

Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System (to 12/2010).

(2) Measure the resistance according to the value(s) in the table below.

Standard resistance:

NG -- REPAIR OR REPLACE FLOOR WIRE NO. 2

OK -- Continue to next step.

4. CHECK CENTER AIRBAG SENSOR ASSEMBLY

(a) Restore the released activation prevention mechanism of connector "B" to the original condition.

(b) Connect the connectors to the front seat outer belt assembly RH and the center airbag sensor assembly.

(c) Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

(d) Turn the ignition switch on (IG), and wait for at least 60 seconds.

(e) Clear the DTCs stored in memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing

Diagnostic Trouble Codes/DTC Check / Clear (to 12/2010).

(f) Turn the ignition switch off.

(g) Turn the ignition switch on (IG), and wait for at least 60 seconds.

(h) Check the DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic

Trouble Codes/DTC Check / Clear (to 12/2010).

OK:

DTC B1905, B1906, B1907, B1908 or 74 is not output.

HINT

Codes other than DTC B1905, B1906, B1907, B1908 and 74 may be output at this time, but they are not related to this check.

NG -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY

OK -- USE SIMULATION METHOD TO CHECK

Short in Front Pretensioner Squib LH Circuit - Airbag System (from 12/2010)