Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 836

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 836

Systems/Testing and Inspection/Component Tests and General Diagnostics/Check For Intermittent Problems

C -- REPAIR CIRCUITS INDICATED BY OUTPUT DTC See: Diagnostic Trouble Code Descriptions/Vehicle Stability Control

System/Diagnostic Trouble Code Chart (to 12/2010)

B -- INSPECT CAN COMMUNICATION SYSTEM See: Powertrain Management/Computers and Control Systems/Information

Bus/Testing and Inspection/Initial Inspection and Diagnostic Overview

A -- Continue to next step.

2. CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION

(a) Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.

(b) Check that the steering wheel is centered correctly while driving straight ahead.

HINT

If front wheel alignment and steering position are adjusted as a result of an off-centered position of the steering wheel, acquire

yaw rate and acceleration sensor zero point again after the adjustments are completed.

OK:

The steering wheel is centered correctly

NG -- ADJUST FRONT WHEEL ALIGNMENT OR STEERING POSITION

OK -- Continue to next step.

3. RECONFIRM DTC

(a) Turn the ignition switch off.

(b) Clear the DTCs See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Reading and

Clearing Diagnostic Trouble Codes/DTC Check / Clear (to 12/2010).

(c) Start the engine.

(d) Drive the vehicle and turn the steering wheel to the right and left at the speed of 35 km/h (22 mph) or more.

(e) Check if the same DTC is output See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and

Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear (to 12/2010).

Result:

HINT

* If the same DTC C1439/66 and/or C1445/66 is not output again, the DTC may have been stored due to a temporary loss of the

steering angle zero calibration, such as when the power voltage drops.

* If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next

step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related

Diagnostic Procedures/Vehicle Stability Control System/Problem Symptoms Table (to 12/2010).

B -- REPAIR CIRCUITS INDICATED BY OUTPUT DTC See: Diagnostic Trouble Code Descriptions/Vehicle Stability Control

System/Diagnostic Trouble Code Chart (to 12/2010)

A -- END

Steering Angle Sensor Initialization Incomplete (from 12/2010)

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: C1439/66,C1445/66: Steering Angle Sensor Initialization Incomplete

C1445/66 - Vehicle Driven with Steering Angle Sensor not Initialized

DESCRIPTION

The skid control ECU acquires the steering angle sensor zero point every time the ignition switch is turned to the ON position and the vehicle is

driven at 35 km/h (22 mph) or more for approximately 5 seconds. The ECU also stores previous zero point.

DTCs C1439/66 and C1445/66 will be cleared when the ignition switch is turned off.