Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 922

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 922

(e) Check for a short in the circuit.

(1) Release the activation prevention mechanism built into connector "B" See: Restraints and Safety Systems/Air Bag

Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System (from 12/2010).

(2) Measure the resistance according to the value(s) in the table below.

Standard resistance:

NG -- REPAIR OR REPLACE FLOOR WIRE

OK -- Continue to next step.

4. CHECK CENTER AIRBAG SENSOR ASSEMBLY

(a) Restore the released activation prevention mechanism of connector "B" to the original condition.

(b) Connect the connectors to the front seat outer belt assembly LH and the center airbag sensor assembly.

(c) Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

(d) Turn the ignition switch on (IG), and wait for at least 60 seconds.

(e) Clear the DTCs stored in memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing

Diagnostic Trouble Codes/DTC Check / Clear (from 12/2010).

(f) Turn the ignition switch off.

(g) Turn the ignition switch on (IG), and wait for at least 60 seconds.

(h) Check the DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic

Trouble Codes/DTC Check / Clear (from 12/2010).

OK:

DTC B1900, B1901, B1902, B1903 or 73 is not output.

HINT

Codes other than DTC B1900, B1901, B1902, B1903 or 73 may be output at this time, but they are not related to this check.

NG -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY

OK -- USE SIMULATION METHOD TO CHECK

Vehicle Speed or Engine Speed Signal Malfunction - Tire Pressure Monitoring (to 12/2010)