Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 920

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 920

(b) Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

(c) Disconnect the connectors from the front seat outer belt assembly LH.

(d) Connect the SST (resistance 2.1 Ohms) to connector "C".

CAUTION:

Never connect a tester to the front seat outer belt assembly LH (driver side front pretensioner squib) for measurement, as this

may lead to a serious injury due to airbag deployment.

NOTICE:

* Do not forcibly insert the SST into the terminals of the connector when connecting.

* Insert straight the SST into the terminals of the connector.

SST : 09843-18061

(e) Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

(f) Turn the ignition switch on (IG), and wait for at least 60 seconds.

(g) Clear the DTCs stored in memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing

Diagnostic Trouble Codes/DTC Check / Clear (from 12/2010).

(h) Turn the ignition switch off.

(i) Turn the ignition switch on (IG), and wait for at least 60 seconds.

(j) Check the DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic

Trouble Codes/DTC Check / Clear (from 12/2010).

OK:

DTC B1900, B1901, B1902, B1903 or 73 is not output.

HINT

Codes other than DTC B1900, B1901, B1902, B1903 and 73 may be output at this time, but they are not related to this check.

OK -- REPLACE FRONT SEAT OUTER BELT ASSEMBLY LH

NG -- Continue to next step.

2. CHECK CONNECTOR

(a) Turn the ignition switch off.

(b) Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.