Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 813

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 813

(c) Disconnect the SST from connector "C".

(d) Check that the instrument panel wire connector (on the driver side knee airbag assembly side) is not damaged.

OK:

The lock button is not disengaged, or the claw of the lock is not deformed or damaged.

NG -- REPAIR OR REPLACE INSTRUMENT PANEL WIRE

OK -- Continue to next step.

3. CHECK INSTRUMENT PANEL WIRE (DRIVER SIDE KNEE AIRBAG SQUIB CIRCUIT)

(a) Disconnect the connectors from the center airbag sensor assembly.

(b) Check for a short to B+ in the circuit.

(1) Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

(2) Turn the ignition switch on (IG).

(3) Measure the voltage according to the value(s) in the table below.

Standard voltage:

(c) Check for an open in the circuit.

(1) Turn the ignition switch off.

(2) Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

(3) Measure the resistance according to the value(s) in the table below.

Standard resistance:

(d) Check for a short to ground in the circuit.

(1) Measure the resistance according to the value(s) in the table below.