Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 984

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 984

OK:

There is no clearance between the sensor and rear axle carrier.

NOTICE:

Check the speed sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes / Traction Control

Systems/Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure (to 12/2010).

NG -- INSTALL REAR SPEED SENSOR CORRECTLY OR REPLACE REAR SPEED SENSOR

OK -- Continue to next step.

7. INSPECT REAR SPEED SENSOR

(a) Disconnect the rear speed sensor connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

LH

RH

NOTICE:

Check the speed sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes / Traction Control

Systems/Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure (to 12/2010).

NG -- REPLACE REAR SPEED SENSOR

OK -- Continue to next step.

8. CHECK HARNESS AND CONNECTOR (REAR SPEED SENSOR TO SKID CONTROL ECU)

(a) SKID CONTROL ECU TO SKID CONTROL SENSOR WIRE