Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 644

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 644

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (GND2 CIRCUIT)

OK -- Continue to next step.

2. PERFORM ACTIVE TEST USING TECHSTREAM (ABS MOTOR RELAY OPERATION)

(a) Connect Techstream to the DLC3.

(b) Start the engine.

(c) Select the Active Test on the Techstream.

(d) Check the operating sound of the ABS motor relay when operating it with the Techstream.

ABS/VSC/TRAC

OK:

The operating sound of the ABS motor relay is heard.

NG -- REPLACE ABS & TRACTION ACTUATOR ASSEMBLY

OK -- Continue to next step.

3. RECONFIRM DTC

(a) Clear the DTC See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Reading and

Clearing Diagnostic Trouble Codes/DTC Check / Clear (from 12/2010).

(b) Start the engine.

(c) Drive the vehicle at the speed of 7 km/h (4.3 mph) or more.

(d) Check that the same DTC is recorded See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and

Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear (from 12/2010).

HINT

Reinstall the sensors, connectors, etc. and restore the vehicle to its prior conditions before rechecking for DTCs.

Result:

HINT

* If a speed signal of 6 km/h (4 mph) or more is input to the skid control ECU, with the ignition switch on (IG) and the stop light

switch OFF, the ECU performs self diagnosis of the motor and solenoid circuits.

* If a normal system code is output (trouble code is not output), slightly jiggle the connectors, wire harness, and fuses of the ABS

& TRACTION actuator assembly. Make sure that no DTCs are output.