Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 960

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 960

OK:

No scratches or foreign matter on the sensor tip.

NOTICE:

Check the speed sensor signal after cleaning or replacement See: Brakes and Traction Control/Antilock Brakes / Traction

Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure (from 12/2010).

NG -- CLEAN OR REPLACE SPEED SENSOR

OK -- CLEAN OR REPLACE SPEED SENSOR ROTOR

Receiver Error - Tire Pressure Monitoring (to 12/2010)

TIRE AND WHEEL: TIRE PRESSURE WARNING SYSTEM: C2176/76: Receiver Error

C2176/76 - Receiver Error

DESCRIPTION

When the tire pressure warning ECU is detected to internal data error, DTC C2176/76 is stored.

INSPECTION PROCEDURE

NOTICE:

* When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and note

them down before removal.

* It is necessary to perform the initialization See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring

System/Testing and Inspection/Programming and Relearning/Initialization (to 12/2010) after the registration See:

Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Testing and Inspection/Programming and

Relearning/Registration (to 12/2010) of the transmitter IDs into the tire pressure warning ECU if the ECU and/or one of the

valve and transmitters have been replaced.

PROCEDURE

1. CHECK DTC OUTPUT (C2176/76)

(a) Clear the DTC See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Testing and Inspection/Reading and

Clearing Diagnostic Trouble Codes/DTC Check / Clear (to 12/2010).

(b) Turn the ignition switch off.

(c) Turn the ignition switch on (IG) and check for DTCs See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring

System/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear (to 12/2010).

OK:

DTC C2176/76 is not output.

NG -- REPLACE TIRE PRESSURE WARNING ECU See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring

System/Tire Pressure Module/Service and Repair/Removal (to 12/2010)

OK -- END

Receiver Error - Tire Pressure Monitoring (from 12/2010)

TIRE AND WHEEL: TIRE PRESSURE WARNING SYSTEM: C2176/76: Receiver Error

C2176/76 - Receiver Error

DESCRIPTION

When the tire pressure warning ECU is detected to internal data error, DTC C2176/76 is stored.