Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 986
NG -- REPAIR OR REPLACE SKID CONTROL SENSOR WIRE
OK -- Continue to next step.
10. INSPECT SPEED SENSOR AND SENSOR ROTOR SERRATIONS
(a) INSPECTION USING OSCILLOSCOPE
(1) Disconnect the rear speed sensor connector.
(2) Connect the oscilloscope to terminals 1 and 2 of the rear speed sensor.
(3) Check that a waveform is output when the tires are rotated.
OK:
A waveforms as shown in the figure should be output.
HINT
* As vehicle speed (wheel rotation speed) increases, the width of the waveform narrows and the fluctuation in the output voltage
becomes greater.
* When noise is identified in the waveform on the oscilloscope, error signals are generated due to rotor scratches, looseness or
foreign matter attached to the speed sensor.
NG -- CLEAN OR REPLACE SPEED SENSOR AND SENSOR ROTOR
OK -- Continue to next step.
11. READ VALUE USING TECHSTREAM (REAR SPEED SENSOR)
(a) Connect the Techstream to the DLC3.
(b) Start the engine.
(c) Select the Data List mode on the Techstream.
TOYOTA DIAGNOSIS AND REPAIR, MAINTENANCE, PARTS AND LABOR, SHOP OPERATIONS, TECHNICIAN'S REFERENCE, DIAGNOSTIC TROUBLE CODES(dtc), RELAYS AND MODULES, SENSORS AND SWITCHES,ENGINE, COOLING AND EXHAUST, POWERTRAIN MANAGEMENT, TRANSMISSION AND DRIVETRAIN, BRAKES AND TRACTION CONTROL, STARTING AND CHARGING, POWER AND GROUND DISTRIBUTION, STEERING AND SUSPENSION, HEATING AND AIR CONDITIONING, RESTRAINTS AND SAFETY SYSTEMS, ACCESSORIES AND OPTIONAL EQUIPMENT, BODY AND FRAME,CRUSIS CONTROL.
Wednesday, December 23, 2020
Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 986
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment