Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 81
HINT
* *1: If the ignition switch is turned off after idling for 60 seconds, this DTC may be stored when the engine is started again.
* *2: Even if no fault is present, this DTC may be stored depending on the battery condition or engine start voltage.
NOTICE:
* Before starting troubleshooting, be sure to clear the DTCs stored due to the reasons described in the HINT above. Then, check
for DTCs and troubleshoot according to the output DTCs.
* The radio receiver assembly is the master unit.
* Be sure to clear and recheck for DTCs after the inspection is completed to confirm that no DTCs are output.
INSPECTION PROCEDURE
NOTICE:
Be sure to read Description before performing the following procedure.
PROCEDURE
1. CHECK RADIO RECEIVER POWER SOURCE CIRCUIT
HINT
Refer to Radio Receiver Power Source Circuit See: Accessories and Optional Equipment/Radio, Stereo, and Compact
Disc/Testing and Inspection/Component Tests and General Diagnostics/Radio Receiver Power Source Circuit (to 12/2010).
If the power source circuit is operating normally, proceed to the next step.
NEXT -- Continue to next step.
2. INSPECT RADIO RECEIVER ASSEMBLY
(a) Disconnect the radio receiver assembly connectors.
(b) Measure the resistance according to the value(s) in the table below.
TOYOTA DIAGNOSIS AND REPAIR, MAINTENANCE, PARTS AND LABOR, SHOP OPERATIONS, TECHNICIAN'S REFERENCE, DIAGNOSTIC TROUBLE CODES(dtc), RELAYS AND MODULES, SENSORS AND SWITCHES,ENGINE, COOLING AND EXHAUST, POWERTRAIN MANAGEMENT, TRANSMISSION AND DRIVETRAIN, BRAKES AND TRACTION CONTROL, STARTING AND CHARGING, POWER AND GROUND DISTRIBUTION, STEERING AND SUSPENSION, HEATING AND AIR CONDITIONING, RESTRAINTS AND SAFETY SYSTEMS, ACCESSORIES AND OPTIONAL EQUIPMENT, BODY AND FRAME,CRUSIS CONTROL.
Tuesday, December 15, 2020
Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 81
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment