Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 965

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 965

OK:

The installation bolt is tightened properly.

There is no clearance between the sensor and front steering knuckle.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

NOTICE:

Check the speed sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes / Traction Control

Systems/Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure (to 12/2010).

NG -- INSTALL FRONT SPEED SENSOR CORRECTLY OR REPLACE FRONT SPEED SENSOR

OK -- Continue to next step.

7. INSPECT FRONT SPEED SENSOR

(a) Make sure that there is no looseness at the locking part and connecting part of the connectors.

(b) Disconnect the front speed sensor connectors.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

LH

RH

NOTICE:

Check the speed sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes / Traction Control

Systems/Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure (to 12/2010).

NG -- REPLACE FRONT SPEED SENSOR

OK -- Continue to next step.

8. CHECK HARNESS AND CONNECTOR (FRONT SPEED SENSOR TO SKID CONTROL ECU)

(a) Disconnect the skid control ECU connector and the front speed sensor connectors.