Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 808

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 808

(c) Disconnect the connector from the driver side knee airbag assembly.

(d) Connect the SST (resistance 2.1 Ohms) to connector "C".

CAUTION:

Never connect a tester to the driver side knee airbag assembly (driver side knee airbag squib) for measurement, as this may lead

to a serious injury due to airbag deployment.

NOTICE:

* Do not forcibly insert the SST into the terminals of the connector when connecting.

* Insert straight the SST into the terminals of the connector.

SST : 09843-18061

(e) Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

(f) Turn the ignition switch on (IG), and wait for at least 60 seconds.

(g) Clear the DTCs stored in memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing

Diagnostic Trouble Codes/DTC Check / Clear (to 12/2010).

(h) Turn the ignition switch off.

(i) Turn the ignition switch on (IG), and wait for at least 60 seconds.

(j) Check the DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic

Trouble Codes/DTC Check / Clear (to 12/2010).

OK:

DTC B1860, B1861, B1862, B1863 or 64 is not output.

HINT

Codes other than DTC B1860, B1861, B1862, B1863 and 64 may be output at this time, but they are not related to this check.

OK -- REPLACE DRIVER SIDE KNEE AIRBAG ASSEMBLY

NG -- Continue to next step.

2. CHECK CONNECTOR

(a) Turn the ignition switch off.

(b) Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

(c) Disconnect the SST from connector "C".

(d) Check that the instrument panel wire connector (on the driver side knee airbag assembly side) is not damaged.

OK:

The lock button is not disengaged, or the claw of the lock is not deformed or damaged.

NG -- REPAIR OR REPLACE INSTRUMENT PANEL WIRE

OK -- Continue to next step.

3. CHECK INSTRUMENT PANEL WIRE (DRIVER SIDE KNEE AIRBAG SQUIB CIRCUIT)

(a) Disconnect the connectors from the center airbag sensor assembly.