Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 944

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 944

* After selecting the "check mode" (signal check), perform the simulation method by wiggling each connector of the airbag

system or driving the vehicle on a city or rough road See: Restraints and Safety Systems/Air Bag Systems/Testing and

Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System (from 12/2010).

PROCEDURE

1. CHECK FRONT SEAT OUTER BELT ASSEMBLY RH (FRONT PASSENGER SIDE FRONT PRETENSIONER SQUIB)

(a) Turn the ignition switch off.

(b) Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

(c) Disconnect the connectors from the front seat outer belt assembly RH.

(d) Connect the SST (resistance 2.1 Ohms) to connector "C".

CAUTION:

Never connect a tester to the front seat outer belt assembly RH (front passenger side front pretensioner squib) for measurement,

as this may lead to a serious injury due to airbag deployment.

NOTICE:

* Do not forcibly insert the SST into the terminals of the connector when connecting.

* Insert straight the SST into the terminals of the connector.

SST : 09843-18061

(e) Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

(f) Turn the ignition switch on (IG), and wait for at least 60 seconds.

(g) Clear the DTCs stored in memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing

Diagnostic Trouble Codes/DTC Check / Clear (from 12/2010).

(h) Turn the ignition switch off.

(i) Turn the ignition switch on (IG), and wait for at least 60 seconds.

(j) Check the DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic

Trouble Codes/DTC Check / Clear (from 12/2010).

OK:

DTC B1905, B1906, B1907, B1908 or 74 is not output.

HINT

Codes other than DTC B1905, B1906, B1907, B1908 and 74 may be output at this time, but they are not related to this check.