Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 945

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 945

OK -- REPLACE FRONT SEAT OUTER BELT ASSEMBLY RH

NG -- Continue to next step.

2. CHECK CONNECTOR

(a) Turn the ignition switch off.

(b) Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

(c) Disconnect the SST from connector "C".

(d) Check that the floor wire No. 2 connector (on the front seat outer belt assembly RH side) is not damaged.

OK:

The lock button is not disengaged, or the claw of the lock is not deformed or damaged.

NG -- REPAIR OR REPLACE FLOOR WIRE NO. 2

OK -- Continue to next step.

3. CHECK FLOOR WIRE NO. 2 (FRONT PASSENGER SIDE FRONT PRETENSIONER SQUIB CIRCUIT)

(a) Disconnect the connectors from the center airbag sensor assembly.

(b) Check for a short to B+ in the circuit.

(1) Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

(2) Turn the ignition switch on (IG).

(3) Measure the voltage according to the value(s) in the table below.

Standard voltage:

(c) Check for an open in the circuit.

(1) Turn the ignition switch off.

(2) Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

(3) Measure the resistance according to the value(s) in the table below.