Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 946
(d) Check for a short to ground in the circuit.
(1) Measure the resistance according to the value(s) in the table below.
Standard resistance:
(e) Check for a short in the circuit.
(1) Release the activation prevention mechanism built into connector "B" See: Restraints and Safety Systems/Air Bag
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System (from 12/2010).
(2) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPAIR OR REPLACE FLOOR WIRE NO. 2
OK -- Continue to next step.
4. CHECK CENTER AIRBAG SENSOR ASSEMBLY
(a) Restore the released activation prevention mechanism of connector "B" to the original condition.
(b) Connect the connectors to the front seat outer belt assembly RH and the center airbag sensor assembly.
(c) Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
(d) Turn the ignition switch on (IG), and wait for at least 60 seconds.
(e) Clear the DTCs stored in memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/DTC Check / Clear (from 12/2010).
(f) Turn the ignition switch off.
(g) Turn the ignition switch on (IG), and wait for at least 60 seconds.
(h) Check the DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear (from 12/2010).
OK:
DTC B1905, B1906, B1907, B1908 or 74 is not output.
No comments:
Post a Comment