Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 843

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 843

(i) When the "ID Tire Inflation Pressure" data (ID1 to ID5) has changed, repeat this procedure to identify the tire pressure warning valve

and transmitter that corresponds to the DTC.

(j) When all of the "ID Tire Inflation Pressure" data (ID1 to ID5) have changed, identify the malfunctioning tire pressure warning valve

and transmitter based on the ID numbers and output DTC.

Result:

NOTICE:

* It takes about 2 or 3 minutes to display the updated data.

* If "ID Tire Inflation Pressure" data has not changed, reset the tire pressure to the appropriate specified value and rotate the

tire 90 to 270 degrees. Then forcibly transmit the transmitter ID and recheck it.

* Record the transmitter ID and position that is normal condition.

NEXT -- Continue to next step.

3. REPLACE TIRE PRESSURE WARNING VALVE AND TRANSMITTER

(a) Replace the identified tire pressure warning valve and transmitter with a new one See: Instrument Panel, Gauges and Warning

Indicators/Tire Monitoring System/Tire Pressure Sensor/Service and Repair/Removal and Replacement/Removal.

HINT

* Before installing a new tire pressure warning valve and transmitter, read and write down its transmitter ID.

* The IDs for the tire pressure warning valve and transmitter not to be replaced should be checked using the Techstream and

recorded.

NEXT -- Continue to next step.

4. CHECK REGISTRATION OF TRANSMITTER ID

(a) Register the transmitter ID for 5 wheels See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Testing and

Inspection/Programming and Relearning/Registration (to 12/2010).

NEXT -- Continue to next step.

5. PERFORM INITIALIZATION

(a) Perform the initialization See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Testing and

Inspection/Programming and Relearning/Initialization (to 12/2010).

NEXT -- Continue to next step.

6. READ VALUE USING TECHSTREAM (TIRE INFLATION PRESSURE)

(a) Make sure that the ignition switch is off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch on (IG).

(d) Turn the Techstream on.

(e) Check the values by referring to the table below. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

Tire Pressure Monitor: