Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 1013

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 1013

INSPECTION PROCEDURE

NOTICE:

When replacing the ABS & TRACTION actuator assembly, perform zero point calibration See: Brakes and Traction

Control/Antilock Brakes / Traction Control Systems/Acceleration/Deceleration Sensor/Testing and Inspection/Calibration (to

12/2010).

PROCEDURE

1. INSPECT STOP LIGHT OPERATION

(a) Check that the stop light comes on when the brake pedal is depressed and goes off when the brake pedal is released.

OK:

NG -- CHECK STOP LIGHT CIRCUIT

OK -- Continue to next step.

2. READ VALUE USING TECHSTREAM (MASTER CYLINDER PRESSURE SENSOR)

(a) Connect the Techstream to the DLC3.

(b) Start the engine.

(c) Select the Data List mode on the Techstream.

ABS/VSC/TRAC

(d) Check that the brake fluid pressure value of the master cylinder pressure sensor observed on the Techstream changes when the brake

pedal is depressed.

OK:

When the pedal is depressed, voltage displayed on the Techstream increases.

NG -- REPLACE ABS & TRACTION ACTUATOR ASSEMBLY

OK -- Continue to next step.

3. READ VALUE USING TECHSTREAM (STOP LIGHT SWITCH)

(a) Select the Data List mode on the Techstream.