Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 1012

Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 1012

(a) Disconnect the yaw rate and acceleration sensor connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

NOTICE:

Check the yaw rate and acceleration sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes /

Traction Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure (from 12/2010).

HINT

If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next

step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related

Diagnostic Procedures/Vehicle Stability Control System/Problem Symptoms Table (from 12/2010).

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)

OK -- REPLACE YAW RATE AND ACCELERATION SENSOR

Master Cylinder Pressure Sensor Malfunction - Vehicle Stability Control System (to 12/2010)

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: C1246/46,C1281/81: Master Cylinder Pressure Sensor Malfunction

C1281/81 - Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC)

DESCRIPTION

Master cylinder pressure sensor is connected to the skid control ECU in the ABS & TRACTION actuator assembly.

DTC C1281/81 is output only in the Test Mode.